Remko RKS 435 H Manual de usuario descargar pdf (Pagina 9)

Choosing the installation

location

The outdoor unit is designed for

horizontal upright installation

outdoors.

The installation location for the

unit must be horizontal, ﬂat and

stable. The unit must also be se-

cured against tipping.

The outdoor unit can be set up

either outside or inside a building.

For outdoor installation, follow

the instructions below to protect

the unit against the effects of the

weather.

Rain

For ﬂoor or roof installation, the

unit must be installed with at least

10 cm of ground clearance.

On cooling and heating units,

raised installation increases the

heating capacity produced.

A base bracket is available as an

accessory.

Sun

The ﬁn exchanger (condenser) for

the outdoor unit is a component

that emits heat.

Sunlight increases the temperature

of the ﬁns and thus reduces the

heat discharged by the ﬁn ex-

changer.

Where possible, the outdoor unit

should be installed on the North-

ern side of the relevant building.

Shading should be set up if re-

quired. This can take the form of a

small roof.

However, the measures taken may

not affect the emerging ﬂow of

hot air.

Wind

If the unit is to be installed in

windy locations, it must be en-

sured that the emerging ﬂow

of hot air is carried away in the

prevailing wind direction. If this is

not possible, the customer should

provide wind protection. Make

sure that the wind protection does

not block the air supply to the unit.

Installation inside buildings



Ensure adequate heat dissipation if the outdoor unit is to be installed

in a cellar, loft, adjoining room or corridor.



Install an additional fan, which should have the same volumetric air

ﬂow as the outdoor unit to be installed in the room and be capable of

compensating for any additional pressure losses caused by air ducts.

Snow

In regions with heavy snowfall,

you should install the unit on the

wall.

It should be installed at least 20 cm 20 cm20 cm

above the highest expected snow

level to prevent snow from pen-

etrating into the outdoor unit.

A wall bracket is available as an

accessory.

Minimum clearance to snow

Installation inside buildings

Wind

20 cm

Hot air

Cold fresh

air

Light well

Outdoor unit

Hot air

Light well

Additional

fan

Snow

Wind protection

1 2 3 4 5 6 7 8 9 10 11 12 13 14 ... 19 20

Comentarios a estos manuales

Sin comentarios

Remko RKS 435 H Manual de usuario Pagina 9

Comentarios a estos manuales

Relacionado con productos y manuales para Acondicionadores Remko RKS 435 H