Remko RKV 13 T Manual de usuario

REMKO – powerful like a bear REMKO RKV 13 T / 24 T Wall/Ceiling Chests Edition GB – P05 Operation Technology Spare Parts

10 1) Capacities based on ISO R 859A; room temperature of TK 27°C/FK 19°C - outside temperature 35°C 2) For connection lines of 5 m or longer 3) Noise

11 Assembly Instructions for Service Personnel Important instructions prior to installation à Ensure that the contents of the package are com-plete a

12 The wall mount is attached with screws (supplied) and dowels suitable for attachment as shown below (rear view, all measurements in mm). Make sure

13 8. The condensation and control lines also have to be connected and, depending on the selected option, guided to the outside. Described below.

14 Electrical wiring diagram Connections to the outdoor units RKS and RKM The connection terminals of the outdoor units can have different labels dep

15 Connection terminal Pump Reservoir Drainage conntors External Condensation Pump The condensation pump which can be purchased as an accessory (Ref.

16 Length of line Hose diameter Additional quantity per m Up to and including 5 m - - 6.35 mm Ø / 1/4‘‘ 15 g/m 9.52 mm Ø / 3/8‘‘ 18 g/m 5 m up to

17 The unit may only be put into operation by the manufacturer or an authorised representative. Initial operation must be performed using the certifi

18 Certification for  Initial operation  Subsequent operation of a REMKO air-conditioning unit / system Outdoor part Indoor unit

REMKO GmbH & Co. KG Klima- und Wärmetechnik D-32791 Lage • Im Seelenkamp 12 D-32777 Lage • PO Box 1827 Phone +49 (5232) 606 - 0 Fax

3 Always keep these operating instructions near or on the unit! Contents Page Safety Hint

4 Safety Hints Extensive tests have been conducted on the material, functionality and quality of these units before they were shipped. These units ma

5 Operation Inserting the batteries into the remote control Prior to initial operation, the batteries supplied with the unit (2 type AAA batteries) m

6 Button functionality The following commands can be performed using the remote control at a distance of no more than 7m. Point the remote control at

7 SWING HEAT 25.0 °c HEAT mode This mode is not active for these models. HEAT SWING AUTO 25.0 °c FAN AUTO AUTO mode These models work exclusively in c

8 à Keep the units free of dirt, plants and other deposits and only clean the units with a damp cloth (do not expose them to a direct stream of water)

9 Before any work on the units is performed, they must be disconnected from the power supply (fuse or repair switch) and prevented from being inadv