Remko RKS 435 H Manual de usuario descargar pdf (Pagina 12)

Condensation connection

Because the temperature on the

condensation is formed during

heating.

The lower housing cover on the

outdoor unit takes the form of a

collector. The condensation con- The condensation con-The condensation con-

nection supplied is to be ﬁtted

here.



The on-site condensation pipe

must be laid with a gradient of

at least 2%.

If necessary, ﬁt insulation that is

resistant to vapour diffusion.



When operating the unit at an

external temperature of less

than 0°C, the condensation

pipe must be laid with frost

protection. The customer must The customer mustThe customer must

keep the lower housing cover

free of frost to guarantee con-

stant drainage of the condensa-

tion. If necessary, auxiliary pipe

heating should be ﬁtted.



After laying the pipes, free

drainage of the condensation

must be tested and permanent

impermeability ensured.

Electrical connection

The connections on the outdoor

unit are located inside the unit

above the connecting valves.

The conductor cross-section of

the power supply depends on the

structural conditions and the con-

nected load of the unit.

Connecting the outdoor unit

Before starting the connection,

observe the following instructions:

Connecting the RXW 350

wall unit

A power supply to the indoor unit

and a 5-wire control line from the

outdoor unit to the indoor unit

must be installed.

Connecting the RXW 480

wall unit

A power supply to the indoor unit

and a 6-wire control line from the

outdoor unit to the indoor unit

must be installed.



The power supply comes from

the connecting terminals on the

RXW indoor unit.

We recommend using a master

switch and a repair switch.



If the lines are installed in areas

with strong magnetic ﬁelds, the

control lines should be shielded.

 The outdoor unit is actuated

by the connecting line from the

indoor unit.



The system is fused as set out

in the technical data.

Connecting the RXD

ceiling cassette

A power supply to the outdoor

unit and a 6-wire control line from

the outdoor unit to the indoor unit

must be installed.



The customer must install the

connecting box close to the

outdoor unit.

We recommend using a master

switch and a repair switch.

 If the lines are installed in areas

with strong magnetic ﬁelds, the

control lines should be shielded.

 The power supply to the indoor

unit comes from the connecting

line from the outdoor unit.

 The system is fused as set out in

the technical data.

The procedure for connecting the

line is as follows:

1. Remove the unit cover.Remove the unit cover.

2. Remove the side panels on theRemove the side panels on the

connection.

3. Select the cross-section of theSelect the cross-section of the

connecting line based on the

speciﬁcations.

4. Run the two lines through theRun the two lines through the

edge protection rings on the

ﬁxed connecting plate.

5. Connect the lines as shown inConnect the lines as shown in

the connection diagram.

6. Secure the line in the strainSecure the line in the strain

relief and re-assemble the unit.

REMKO RKS

1 2 ... 7 8 9 10 11 12 13 14 15 16 17 18 19 20

Comentarios a estos manuales

Sin comentarios

Remko RKS 435 H Manual de usuario Pagina 12

Comentarios a estos manuales

Relacionado con productos y manuales para Acondicionadores Remko RKS 435 H