Remko MHP-Manager Wireless Remote Control Manual de usuario descargar pdf (Pagina 26)

Only the error with the highest priority is displayed.

- The message "Error" appears on the standard display and the error number in the Favourites line.

The error can be rotated out of view and rotated back into view on the display => see Favourites.

- In the Display menu, at the end of the System sub-menu the parameter Error appears, which displays the latest

error.

Error indication by code

Type of error Code Cause Required action

Communications

error

E 90 Addr. 0 and 1 on bus Bus codes 0 and 1 may not be used simultaneously

E 91 Bus code assigned The set bus code is already being used by another device

E 241 No communication with HA Check range from HF-CAN

Internal error E 81

EEPROM error. The invalid

value has been replaced

by the default value

Check parameter values!

Sensor error

(break/short-circuit)

E 67 Collector sensor 2 Contact specialist dealer

E 68 Collector sensor 1 Contact specialist dealer

E 69 Supply sensor, HC2 Contact specialist dealer

E 70 Supply sensor, HC1 Contact specialist dealer

E 75 Outdoor sensor Contact specialist dealer

E 76 Tank sensor Contact specialist dealer

E 77 Boiler sensor Contact specialist dealer

E 78 Collector sensor Contact specialist dealer

E 79 Sensor, multifunction relay 1 Contact specialist dealer

E 80 Room sensor, HC1 Contact specialist dealer

E 83

Room sensor, HC2 / Lower

buffer sensor / Swimming pool

sensor

Contact specialist dealer

E 84 Humidistat Contact specialist dealer

Message W 85 Battery needs changing Insert new batteries

REMKO WIRELESS REMOTE CONTROL

FOR MULTITALENT HEAT PUMP MANAGER

1 2 ... 21 22 23 24 25 26 27 28 29 30 31 32

Sin comentarios

Remko MHP-Manager Wireless Remote Control Manual de usuario Pagina 26